Mida otsite?

Otsige artiklite, toodete, lahenduste jne alusel...

Meil on kahju!

Otsitulemusi ei leitud.

Sisselogimine

Unustasite oma parooli?

Olete uus klient?

Registreeruge ja teil on palju eeliseid:

Toote olemasolu kontroll
Kiire taastellimine ja tellimuste ajalugu
Isiklikud tootesoovitused
Maksmine arvega
Registreerige nüüd

Help & Contact

Your direct line to us

If you have any questions about the online store or our products, you can call our customer service at:

Phone
+49-421-48907-766
Monday - Thursday: 8:00AM - 5:00PM
Friday: 8:00AM - 4:00PM
Except saturdays, sundays and holidays

Or use our FAQ

There you get answers to the most frequently asked questions.

Helping people help themselves
KKK

BV 20-25

Tube bending device tube-OD 20-25
BV20-25

The product image may differ

BV20-25 BV20-25
BV20-25 BV20-25 BV20-25
Pakend
pappkastis 
Toru välimise-Ø jaoks (mm)
20 - 25 
PDF-faili allalaadimine

Palun valige versioon

Kuva artiklitabel

Artikkel

BV 20-25
Detailne teave toote kohta

BV 20-25

Pakend
pappkastis
Toru välimise-Ø jaoks (mm)
20 - 25

Omadused

Lisa
  • without extension 
Materjal
  • Teras 
Paigaldus
  • In vice 
Rakendamine
  • manual 
Tüüp
  • Tube bending tool 20 - 25 
Värv
  • hõbedane 
Customs tariff number
  • 84622998 
Kõik omadused

Tootekirjeldus

Märkused
Please note that a good bending quality can only be achieved if the tube being bent is also made of a flexible material.
The HANSA-FLEX tubes made of steel and stainless steel from our online shop and branches fulfil these characteristics.
Kirjeldus
This robust tube bending equipment is designed for use either in the workshop or during service calls and can be used to precisely bend flexible hydraulic tubes.
The bending lever (with two pins) and the extension piece can be used to bend the tube segment into the desired shape quickly and easily.
Ovalisation of the cross-section of the tube is reduced by the contour clamp in the bending segment.
The bend radius of the segments are: r = 86.5 mm, x = 52 mm.
Application
The tube bending tool can be used wherever a defective pipe cannot or may not be replaced with a hydraulic hose.
If a pipe was previously fitted, a hydraulic hose should only be installed as a temporary solution.
If the bent pipe is professionally installed, it will remain in the position it is fitted.
The bending equipment can be used in the construction, agriculture and forestry sectors, as well as for municipal technology and service and maintenance work.
Tarnemaht
A fixing hook that serves as a pipe stop
Three bending segments 20, 22, 25 mm with holding pins for insertion into a vice
A bending lever with pressure roller (without extension)

Product variants

1 Result
Search
Mõõtmejoonis
Nimetus
Pakend
Toru välimise-Ø jaoks (mm)
BV 20-25
pappkastis 
20 - 25 
Lisateave

Column selection

Pakend
Toru välimise-Ø jaoks (mm)